![]() If you do, the lock may not calibrate itself correctly and have problems locking. Do not install the batteries before you are told to by the installation instructions.Make an appointment with our installation partner OnTech, to have a trained pro come to your home, install and set up your Nest products. However, if there's an issue, you can reinstall your old lock and get installation help. The Nest × Yale Lock works with most standard doors. Keep your old lock handy, just in case.Don’t want to install it yourself? Contact our installation partner, OnTech, to help you check your system’s compatibility, install, and set up your Nest products. Note: If your door's lock holes are out of these specs you can either re-drill the holes after you've removed your current lock. The lock hole center is either 2 ⅜ or 2 ¾ inches from the edge of the door.Your door's thickness should be one of the following:.You can use the template included in the installation manual or a measuring tape. Check that your door meets the following requirements (most standard doors will).However, if there's an issue, you can simply reinstall your old lock and get installation help. The Nest × Yale lock works with most standard doors. You may also need a chisel to reposition the cutout for the latch plate.ĭon’t want to install it yourself? Contact our installation partner, OnTech, to help you check your system’s compatibility, install, and set up your Nest products. Use a 6 cm (2 ⅜ inch) spade drill bit and the template from the installation manual to reposition the holes. If your lock hole's centre isn't either 6 or 7 cm (2 ⅜ or 2 ¾ inches) from the edge of the door, you'll need to re-drill them in the correct place. You may need a different screwdriver or wrench to fit your lock's hardware. Remove the current lock and strike plate if you have one already installed on the door. If your lock does not successfully calibrate, it should automatically unlock. Don't worry about getting locked out during the test. ![]() If you don't, your lock may calibrate itself to your door and jam. Close the door during the lock test as instructed.While your current strike plate may look the same, the Yale plate is engineered to precisely fit your new lock. Install the Nest × Yale strike plate that comes with your lock.Note: If your door's lock holes are out of these specs, you can either re-drill the holes after you've removed your current lock. The lock hole centre is either 6 or 7 cm (2 ⅜ or 2 ¾ inches) from the edge of the door.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |